The Mazda MX5 MK3 is roomier than any other of the models, but offers similar or even less space than them. These lowering brackets for the NC seats with adjustable height offer the full lowering potential available with them on stock rails.
This version goes to the extreme and offers the full possible lowering potential. The seat level drops by 4cm (1.5") - head room from 90.3cm to 94.3cm. The measurements were performed with textile NCFL seats (they might vary to leather ones) and the seat was not defoamed. Defoaming is estimated to provide additional 1.5cm (to be confirmed).
The installation involves cutting the OEM rails to size and removing small edge of the floor sound deadening .
All needed installation hardware is provided, as well as installation manual.
Sold as full kit per side (seat, side coded).
Please note, the first batch is available for shipping only from Bulgaria. I will have them in UK in a week time (after the 16.12.2019). All UK orders will be shipped from Bulgaria until then.
Q:Being height adjustable, would they go lower than the Non Height Adjustable (early NC) seats?
A:No. The early seats allow for lower seating position. The geometry of these seats does not allow lower position as the Non Height Adjustable ones.
Q: Will they fit LHD (RHD) MX5 NC?
A: The Height Adjustable Seats are side coded. You need to order the LHD/RHD specific version.
Q: My car has prefacelift adjustable height seats - will they fit?
A: They will fit seats with height adjustment.
Q: I want to lower both seats in my NCFL, should I order two sets of those brackets?
A: No! These are just for the height adjustable seat and this is usually just the driver side. Means - you need to order NON height adjustable version for the passenger side. As the 3" drop is fairly low, I recommend going for the moderate 1" drop in this case.
|Mazda MX5 Model|