Headlight Air Intake Lid

New Products 2018-08-24 2413

The Jass Performance Headlight Air Intake Lid delivers additional cold air to the engine on both OEM and Jass Low Profie retractable headlights.

Developed to maximize the possible cold air inlet, following the initial curvature lines of the car.

The Headlight Air Intakes are made of fiberglass, delivered with weather resistant black gloss finish. Of course, as expected as bolt on solution with integrated side brackets for OEM installation.

Versions for both sides available.

(Left = Engine Air Box/Filter Side)

headlight_air_intake_lid

Latest Comments

work with my Heat Shield or do I have to modify the HS Ludde

Posted By Lars-Erik Lundin...

Posted By gohichi shinmen...

wing: "Important note: While it has the obvious advantage of being rust proof, important at the location used, the stainless fasteners can take just a bit more torque than fastening the rails securely – 20NM is the recommended torque setting. Stainless steel fasteners tend to gall while being tightened. The risk of galling or thread seizing can be reduced by:  Using lubrication  Tighten fasteners with low rpm’s; without interruptions  Apply only light pressure"

Posted By Vlad...

y " Torque the screws up to 50NM." Thats way too much. M8 needs 25Nm and if the screws are lubricated it's around 20Nm

Posted By Adrian Wenger...

e you can also consider a stainless steel heat shield to be installed in the rear bumper around the exhaust. I've found a couple of options but made of carbon fiber. You know that I'm not a carbon fiber fan and prefer the stainless theme.

Posted By Jose Mestres...

available to assist you at your convenience. I understand that the spanish version will improve your market especially in Latin America. Please be aware that spanish is different depending the country or region. Here in Puerto Rico we are very influenced by the USA and some of our words are described as "spanglish".

ways thought of this idea, when I look at the keyhole, but never came to doing it. Not sure if brushed or mirror polished will suit better there, as of the contract, but I can assure you, I will have this item very soon. As of the indicator/wiper stalks - I have to agree, the alu option is looking good, but you will miss some functionalities and as it is not straight forward DIY job for everyone, I am avoiding producing and releasing it at the moment. Thanks again! Vlad

Posted By Jass Performance...

Name
Email

Same In Category

Latest Comments